Page 1 of 1

static ip setup using sysprep

Posted: Tue May 04, 2010 8:49 am
by tirou
Hi

I am trying to set static IP address using sysprep answer file on a windows 2003 VM. I included the following section as per MS technet article

[Networking] InstallDefaultComponents=Yes[params.MS_TCPIP.Adapter01] SpecificTo = Adapter01 DHCP = No IPAddress = 10.10.10.10 SubnetMask = 255.255.255.0 DefaultGateway = 10.10.10.1

But, when sysprep runs always DHCP gets configured. sysprep ignores whatever static ip I enter under sysprep answer file. Am I missing anything here.

Appreciate any help

Thankstirou2010-05-04 15:50:37

static ip setup using sysprep

Posted: Tue May 04, 2010 8:49 am
by tirou
Hi

I am trying to set static IP address using sysprep answer file on a windows 2003 VM. I included the following section as per MS technet article

[Networking] InstallDefaultComponents=Yes[params.MS_TCPIP.Adapter01] SpecificTo = Adapter01 DHCP = No IPAddress = 10.10.10.10 SubnetMask = 255.255.255.0 DefaultGateway = 10.10.10.1

But, when sysprep runs always DHCP gets configured. sysprep ignores whatever static ip I enter under sysprep answer file. Am I missing anything here.

Appreciate any help

Thankstirou2010-05-04 15:50:37