Please offer an non-MRU-Tab Switching solution!
Posted: Sat Jun 01, 2019 4:26 am
Hello
The PowerShell Studio enforces to use the MRU Tab Switching - even the "Document Selector" Dialog is not representing the user selected Tabs order :-[
The MRU Tab Switching is useful to work with 2 or 3 Files.
At the latest when 5 or more files are open, it's a nightmare.
Then, it's much more useful if the IDE allows switching tabs based on the user selected tabs order, which are e.g. ordered from high-level to low-level code and therefore, we can blindly switch between them. This is very fast and useful!
We are pretty sure that the (despite complaint still undocumented) key combination Ctrl PgUp / PgDn allowed switching the Tabs in the user selected order, but it doesn't work anymore.
Please finally offer to enable / disable MRU Tab switching.
If the MRU Tab switching is disabled, then the "Document Selector" Dialog should list the Files in the order of the Tabs, too.
Thanks a lot,
kind regards,
Jahoschua
The PowerShell Studio enforces to use the MRU Tab Switching - even the "Document Selector" Dialog is not representing the user selected Tabs order :-[
The MRU Tab Switching is useful to work with 2 or 3 Files.
At the latest when 5 or more files are open, it's a nightmare.
Then, it's much more useful if the IDE allows switching tabs based on the user selected tabs order, which are e.g. ordered from high-level to low-level code and therefore, we can blindly switch between them. This is very fast and useful!
We are pretty sure that the (despite complaint still undocumented) key combination Ctrl PgUp / PgDn allowed switching the Tabs in the user selected order, but it doesn't work anymore.
Please finally offer to enable / disable MRU Tab switching.
If the MRU Tab switching is disabled, then the "Document Selector" Dialog should list the Files in the order of the Tabs, too.
Thanks a lot,
kind regards,
Jahoschua