Page 1 of 1

Unable to Debug after installation of latest release

Posted: Thu Apr 24, 2014 4:52 pm
by Double Reddog
I recently installed the latest version of primalscript (7.0.29_042214_x64) and now I am unable to debug scripts. The following error displays when attempting to debug:

The command ""C:\Program Files (x86)\Common Files\SAPIEN Debugger 2014\scriptdriver64V2.exe" -d "C:\temp" -p 52950 -e Debugger " could not be executed.

The operating system reported the following error:

"The specified file was not found."

I looked in the directory (shown above) for the scriptdriver64v2.exe and it's not present. Did the new installation remove that file? How do I correct this? Thanks.

Re: Unable to Debug after installation of latest release

Posted: Thu Apr 24, 2014 6:25 pm
by Alexander Riedel
It appears the installer did not pick up these new files for some reason. I will rebuild the installer and put it up.
It should be available in an hour or so.

Re: Unable to Debug after installation of latest release

Posted: Thu Apr 24, 2014 7:07 pm
by Alexander Riedel
New build is available. Please check with that.

Re: Unable to Debug after installation of latest release

Posted: Thu Apr 24, 2014 7:29 pm
by Double Reddog
That worked. I can now debug. Thanks for addressing this so quickly.